I have a client who is using MS Direct access VPN. The remote access solution has been deployed using ipV6. CUCM has been deployed on the corporate network using ipV4. ipv6<>ipV4 translation is used between the two networks. As there is no way of specifying an IPv6 TFTP server address within the IPC client could it be done using DNS?, ie Is there anyway of forcing the IPC client to use DNS instead of the static IP address for the TFTP address - something in the registry maybe? The IPv6 DNS server would then resolve the TFTP name to a IPv6 address. The IPv6<>IPv4 translator could then translate the v6 address to a real v4 TFTP address.
My company uses DA and we recently deployed CUCM 9.0. As Steve described above, CIPC only communicates using IPv4. DA will not translate IPv4 addresses and there's no option in the CIPC client to use DNS instead of the TFTP server IP addresses. Has anyone found a workaround for this?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...