I have CME 2821, its on LAN with 192.168.0.x IP address, and i have a firewall (Cyberoam), I have NATTED the above address with live ip address so that roaming users can just use the Live ip address and get connected. I cannot do vpn since most of the users are roaming and there is not much requirement for them to log in to the network with VPN, One more problem in configuring vpn for roaming users is limitation of internet access at office, and most of the remote users are reluctant to login to the network. My question is 1) Can i use Live IP address in Preference>tftp server . 2) Is their any special configuration to done in order to achieve this ? 3) I have already tried NAT on the firewall from Live to local IP address, but i don't see any request coming from communicator on to CME.
4) I treid with different ISPs and differnt PCs, but it wont connect. CIPC always shows registering, and on cisco i did a debug, but i see no messages there. Any suggestions will be appreciated. Thank YOU
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.