Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2610 and FXO card

I have CM working with 2610 and an FXO card. Everything seems to be working fine except that I don't have caller ID. I've found documentation saying that I need to enter "caller-id" command on the voice port, but this command doesn't exist for me. Is this an IOS version issue? Can someone tell me which feature set I should have for this?

-Shikamaru

2 REPLIES
New Member

Re: Cisco 2610 and FXO card

I assumed the voice port is configured for MGCP, if this is the case then you will need to configure the gateway as H.323 to get caller-id working for the FXO.

Armando

New Member

Re: Cisco 2610 and FXO card

Yes, it is currently configured for MGCP. Thanks for the tip, Armando. Much obliged.

-Shikamaru

98
Views
0
Helpful
2
Replies