Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
203
Views
0
Helpful
2
Replies

Cisco 2610 and FXO card

shikamarunara
Level 4
Level 4

‎03-19-2007 02:22 PM - edited ‎03-14-2019 08:33 PM

I have CM working with 2610 and an FXO card. Everything seems to be working fine except that I don't have caller ID. I've found documentation saying that I need to enter "caller-id" command on the voice port, but this command doesn't exist for me. Is this an IOS version issue? Can someone tell me which feature set I should have for this?

-Shikamaru

Labels:
0 Helpful
2 Replies 2

aramos17428
Level 1
Level 1

‎03-19-2007 06:03 PM

I assumed the voice port is configured for MGCP, if this is the case then you will need to configure the gateway as H.323 to get caller-id working for the FXO.

Armando

0 Helpful

shikamarunara
Level 4
Level 4
In response to aramos17428

‎03-19-2007 08:29 PM

Yes, it is currently configured for MGCP. Thanks for the tip, Armando. Much obliged.

-Shikamaru

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents