cisco 2610XM integration via E1 with siemens hipath 3750 with TMS2
I have a Siemens HiPath 3750 with TMS 2 card set with a protocol (S2M: Euro-ISDN PP WITH CRC4 Euronumeris = T2 + (ETSI) WITH CRC4) to make a connection with a cisco router 2610XM with IOS (c2600-ipvoice-mz.124-25) via an E1 card.
WHat protocol should I use cisco router side.
I ask if i can have a configuration example for this integration because I do not know if I should use the isdn switch-type on Net5 or QSIC, and the E1 controller configuration, and serial interface.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...