Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2801 with one BRI calls drops

Hi,

I have one 2801 (IOS 14.4.15T8) with one BRI the problem is that many calls (inbound ou outbound) trough BRI gets dropped

My config:

network-clock-participate wic 0

network-clock-select 1 BRI0/0/0

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

Usually in another configs i use static tei with no problems.

Layer 1 and Layer 2 are UP in BRI with no calls.

I see a lot of %MARS_NETCLK-3-CLK_TRANS in logging when calls are dropped layer 2 goes dow.

Any suggestions?

Best Regards

MC

1 REPLY
Hall of Fame Super Gold

Re: Cisco 2801 with one BRI calls drops

Can you a try a different IOS ? like YB4 for example.

Note you or may not have static tei, ask telco.

166
Views
0
Helpful
1
Replies