Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 connect to DMS 100

I was wondering if anyone has used a cisco 2811 as a gateway. That is connected to a nortel DMS 100 via pri. Then out of the cisco 2811 go to a poe switch and then to a phone and make a call... I would like some help on this if possible... Thanks

New Member

Re: Cisco 2811 connect to DMS 100

We've done this -- what kind of problems are you having?  Can the DMS do QSIG or just DMS100?

Your 2811 - is it MGCP with Call Manager?

Let me know some details of the troubles you have and your config.

New Member

Re: Cisco 2811 connect to DMS 100

Well we are not doing it through our cm. We are wanting to just make a sip phone register with the 2811 if that is possible. Then just send a pri to the 2811 that will allow numbers in the tdm switch be used. The 2811 is just like a manager to know what dn is associated with what ip address... If that makes any sense...