Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2811 - unable to dial out

I had a 2811 die on me (boot failure - won't come out of rommon). I swapped it out with another 2811 we had in stock, and moved the FXO card from the old one to the new one.

I copied over the same IOS and config the old one was using as well.

Everything came up fine, except outside dialing. I can't seem to configure the voice card.

conf t and then voice-card 0 returns "invalid input" at the 0. That's definitely the slot the card is in, and I've tried the other slots, and the same thing happens.

I'm not the normal Cisco guy here, he's on vacation so I'm hoping someone can help. thanks!

4 REPLIES

Re: Cisco 2811 - unable to dial out

Does the new 2811 have the necessary DSPs to support the card?

Brandon

New Member

Re: Cisco 2811 - unable to dial out

Agreed it sounds like you don't have the DSP resources to run the card..

Inside the old router was a chip (looks like a sim chip) that handles Signal processing/transcoding etc...

Swap that over and see if that helps

Silver

Re: Cisco 2811 - unable to dial out

Hello Marc,

What is the IOS version on that GW, the image name should have a "T" in order to have voice enabled features.

Please post the output of a "show version" and a "show diag" commands.

Hope this helps!

New Member

Re: Cisco 2811 - unable to dial out

Also do a show ver and see if the FXO ports are being recognized...If it doesn't list them and says "Unknown device" then you have the wrong IOS

141
Views
0
Helpful
4
Replies