Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco 2821 : Configuration

Hi,

Since I wasn't able to make the fax working good on my 2801, I m trying with another IOS but on another router (2821)

It's not the first use of this router, but I can't test now in another configuration.

Here are a part of sh ver :

Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(9)T, RELEASE SOFTWARE (fc1)

Cisco 2821 (revision 53.51) with 249856K/12288K bytes of memory.

2 Gigabit Ethernet interfaces

2 Channelized E1/PRI ports

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

So I m trying to report my configuration from my 2801 to this 2821.

But I haven't the command voice-port in this 2821, is that normal ?

I'm not usual with telephony thing...

5 REPLIES
VIP Super Bronze

Re: Cisco 2821 : Configuration

Yousri,

You will only see "voice ports" when you configure pri-time slots on your gateway. The voice ports are automatically created.

Post a copy of your config here

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Community Member

Re: Cisco 2821 : Configuration

Ok,

I have tried, but It tells me that I haven't dsp resource for that...

Need to buy some stuff I think...

Bronze

Re: Cisco 2821 : Configuration

Can you do a show diag and post the output?

VIP Super Bronze

Re: Cisco 2821 : Configuration

Yes,

You need DSPs to terminate voice calls. If you do a show diag, you should see if you have DSPs on your router or not

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Community Member

Re: Cisco 2821 : Configuration

No DSPs on this router.

Just buy one PVDM2-32. Will try after the delivery. Thanks for your help.

435
Views
0
Helpful
5
Replies
CreatePlease to create content