Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3825 how to convert for voice?

Hi I have a Cisco 3825 that is surplus to requirement and I need to convert it for voice for a new office.

It will need to connect to an ISDN30 so I believe I will need a vwic2 1mft E1/T1 controller module.

Where do DSP's come into it? Are they H/W or S/W, are they part of the E1 controller card or is it something else I need?

Any help greatly appreciated!

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Cisco 3825 how to convert for voice?

Hi,

You will need vwic2 1mft E1/T1

That will allow the physical connection of an ISDN30 PRI (E1 =30 channels , T1 24 Channels)

You also require a DSP chip to converts the POTS or PRI to IP packets

For E1/T1 you need

PVDM2-32 to enable all channnels

This plugs in to the PVDM slot on the motherboard of the router ( Yes Lid off)

HTH

Alex

Regards, Alex. Please rate useful posts.
2 REPLIES
Green

Cisco 3825 how to convert for voice?

Hi,

You will need vwic2 1mft E1/T1

That will allow the physical connection of an ISDN30 PRI (E1 =30 channels , T1 24 Channels)

You also require a DSP chip to converts the POTS or PRI to IP packets

For E1/T1 you need

PVDM2-32 to enable all channnels

This plugs in to the PVDM slot on the motherboard of the router ( Yes Lid off)

HTH

Alex

Regards, Alex. Please rate useful posts.
New Member

Cisco 3825 how to convert for voice?

Hi Alex

Great, thanks very much for your help

Simon

244
Views
0
Helpful
2
Replies