CISCO 7911 IP Phone_Registration problem with GNS3_CISCO 7200 Router
Hello . . .
i am trying to build a voice lab over GNS3. my target is to setup call between CISCO IP communicator & CISCO 7911 IP phone. but i am facing a problem regarding the registration of CISCO 7911 IP phone. all the things i have done in my voice lab is presented below:
1. i am using CISCO 7200 router IOS for telephony service setup. 2. the CISCO IP communicator softphone is successfully registered with the 7200 router. 3. also the IP communicator gets an extension number which i have configured during the telephony setup. 4. but the problem i am facing for CISCO 7911 IP phone. 5. at the 7911 phone i have set IP 192.168.10.3/27. i have assign IP 192.168.10.1/27 at the LAN card in which the 7911 phone is directly connected. also at the 7911 phone i have set default router address 192.168.10.1/27. 6. the 7200 router's TFTP server IP is 192.168.10.2/27 7. i can ping the 7911 phone from my pc also from the GNS3 7200 router 8. i can access the web console of 7911 ip phone over http
but the 7911 phone is not getting register with the 7200 router. the 7911 phone not getting an extension.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...