Can anyone please help me with the following , we are installing a new centralized IPT environment , currently we have local old CUCM that we don't have access to , we have bought a new phones 7942 and 7962 that are not configured on the old system but configured on the new one , we are trying to do some tests on the new environment using physical phones , The DHCP is setup and has a TFTP poiting to the OLD CUCM , i cannot change the DHCP settings yet because that will change all of the phones on the site .
Now i need to connect the new phones to the new system by manually changing the TFTP ip address to the new system , when i plug in the phone they take the ip information from the DHCP server to the old CUCM and stuck in registeration loop because it is not configured on the old system , how can i stop the phone from trying to register to the old system to be able to have enough time to change the TFTP settings ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...