Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 7960 with VoipBuster

Hi All,

I've changed my Cisco 7960 firmware to SIP. Also I've configured my phone to call with VoipBuster, but it don't work.

When I turn on my phone, the settings will be downloaded from my TFTP-server. When I go to my SIP configuraton, I see the right Proxy, port, username and password, but in my main screen I see in the top (corner) "VOIPBUSTER SIP" with a phone icon. But in that phone icon, there is a "X". When I try to dial a phone number, the phone say:

To: 0031600000000 (Phone number)

Calling (out INV)

After 180 seconds (i think) the phone says: Reorder.

What do I wrong?

Firmware: P0S3-08-2-00

SIP Configuration:

Name: VoipBuster

Shortname: UNPROVISIONED

Authentication Name: XXXX

Authentication Password: XXXX

Display Name: VoipBuster

Proxy Address: sip.voipbuster.com

Proxy Port: 5060

Danido.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Cisco 7960 with VoipBuster

Ok, in phone config file you may have:

0

try to set 1 and your public address respectively.

3 REPLIES
Hall of Fame Super Gold

Re: Cisco 7960 with VoipBuster

Hi Danido,

Is the phone behind NAT?

Can you take an ethereal trace to see what is going on?

New Member

Re: Cisco 7960 with VoipBuster

Yes, my phone is behind a NAT.

Now I forward this ports to my Phone:

Any 8585 - 8585

Any 5060 - 5070

Any 16384 - 16484

UDP 123 - 123

UDP 69 - 69

But it don't work.

The Show Reg command (with telnet) show's the following:

1 .1x REGISTERING 3600 31 sip.voipbuster.com:5060

Note: APR is Authenticated, Provisioned, Registerd

I've already searched the forums, but I can't find the solution.

Danido

Hall of Fame Super Gold

Re: Cisco 7960 with VoipBuster

Ok, in phone config file you may have:

0

try to set 1 and your public address respectively.

1176
Views
0
Helpful
3
Replies