I recently upgraded the SCCP firmware of my 7970G phone to the latest version 9.2(3). I am not using CUCM for the time being, as I use it at my home with elastix, so I upgraded the firmware using a TFTP server. The problem is that since firmware version 8.3, Cisco probably has changed the SEP<MAC>.cnf.xml file format, as my phone does not recognise it anymore, although it did until around 8.2. The status message states "Error Verifying Config Info".
I would not bother about the file as my phone registers just fine, but I need it to make the appropriate changes to the backlight timeout settings.
Could someone be kind enough to provide me with a sample SEP<MAC>.cnf.xml file from their CUCM server?
I hope my request doesn't violate the Cisco forum TOA.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...