Re: CISCO 9951 SIP Phone SRST system message display
We have a remote site 2951 router running IOS version 15.1.3T . SRST works fine with SCCP phones at this site but the new 8961 or 9951 phone are not failing over in srst mode since you mentioned SRST works for you with these new phones please can you tell me is there anything differnt we have to do than normal SRST config for these new phones. Let me know ASAP . Thanks for your help.
Minimum IOS version supported for these new phones is 15.1.3T so verify that . I did not configure the backup registrar from the guide, just FYI..since UI bug is still not fixed as mentioned above in this post you won't even know phones are in SRST mode unless you verify that on the phone.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...