12-08-2013 01:53 AM - edited 03-16-2019 08:45 PM
Cisco 9971 phone buttons setup as Speed Dial BLFs, User gets the call, hits transfer, hits the speed dial,call is not getting transfered. Instead, it is esablishing another call and there is no way to trasfer the call, also does not appear the transfer softkey, a new call has been created.
Dialing the destination manually works fine.
9971 is runing firmware sip9971-9.3.2-10
and CUCM version is : 9.1.1-10000-11
Pls. suggest
Rgds
Rajesh Kumar
12-08-2013 08:42 AM
Any feedback ?
Rgds
Rajesh Kumar
12-08-2013 01:29 PM
Is the same setup is working in different model of cisco phone?
is the transfer softkey is configured in "connected" state of softkey template
-murali
12-08-2013 09:55 PM
Dear Murali
Transfer works perfectly in other phone model.
I hope you are aware of 9971 phones. There is not softkey template to apply...!!!!
Cisco 9971 is not anymore luxury feature phones.....It is pain.....! End users are vicitim of Cisco's messup....!
Waiting for feedback.
Rgds
Rajesh Kumar
12-08-2013 10:29 PM
Dear All
This was bug issue, upgraded 9971 firmware to 9.4.1, it started working.
Hmmm, as per my experience Cisco 9971 IP phone is full of bug issue since it is released.
Even after couple of years also, bug issues on basic call transfer features.....!!!!
Rgds
Rajesh Kumar
12-09-2013 02:55 AM
Hi Rajesh
Yes, it dosen't has Softkey template, but you can change softkeys using Feature Controll Policies
Regds
$
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide