Hi I am having a problem with one cisco 9971 when I recieved a call i heard a short sound..Then the first button on the left turn on (orange/ambar) and at the same time the first button on the right side start blinking and show me in the screen who is the caller..But the problem is I dont hear the ringtone sound, I have no ringtone ringing.. I have check the configuration and cound find anything.. Any clue? Thanks...
I had this exact same issue. It turned out to be Do Not Disturb. Since this is not a softkey, and isn't controllable throught feature control sets, it must be set as a lince presence. Best as I can figure, DND was set as a line presence (through button templates) enabled by the end-user, and then removed from the line presence, leaving no way to disable it from the phone. Tested in lab and replicates the behavior exactly of a short sound, and then nothing. Could be different depending on your DND settings in CUCM. You can turn DND off directly from the phone config page. Very different behavior than the previous 69xx and 79xx series phones for DND.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...