I finally upgraded my ucm cluster to allow us to add the 9971 phones although, when i plugged in my usb cam (cisco cam) i get the following error? i have check the phone enterprise paramenters and all is enable,
I get the following error when pluggin the cam into the phone
The USB vendor specific device has been detected but is disable by the administrator
The parameters described in the following procedure can be enabled on either the Phone Configuration window (Device > Phone), the Enterprise Phone Configuration window (System > Enterprise Phone Configuration), or the Common Phone Profile window (Device > Device Settings > Common Phone Profile). Be sure to also check the corresponding Override Common Settings parameter in the configuration window. The Phone Configuration window is referenced below for purposes of the procedure description.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.