The phone is connected HP switch.Second, after connect to the network it shows in accessories with USB symbol just for 5 sec then disappear given eror "unable to power the camera.Third ,yes all enabled.
Exactly, hence my question around the switch vendor. I had a customer using Extreme switches few years back where it took me a while to figure out this issue, after reviewing console logs it was evident the phones do not negotiate power requirements for the cameras with non Cisco switches. Disabling power negotiation does the trick.
I recently ran into an issue where the Camera suddenly quit being recognized by the phone. Removing and reinserting the camera did not solve the issue. Neither did resetting all settings on the phone through the administrator settings. I found that downgrading the firmware, and then re-upgrading to the original running version would solve the issue. It seems like the driver was being corrupted somehow.
Running Firmware: sip9971.9-4-1SR1-2
Downgraded to: sip9971.9-4-1-9
Upgraded to : sip9971.9-4-1SR1-2
This happened on two different phone and the above resolution fixed it on both phones.
These are the paths to get to each CCX logs through CLI. They may be helpful if you are having issues accessing RTMT or downloading logs through it.
If you want to download them you have to prefix "file get " and you can add one of the options (re...