We have a ATA 186 with one analog line plugged in and configured as a SCCP device. We were seeing a lot of errors in the UCM event logs due to the second port not being disabled, thefore we registered the second port with UCM using the virtual mac address per the Cisco docs. I now see that both mac's are registered, however they both have the same IP address. I am wondering if this is going to be an issue when it comes to routing the call? The DN is only associated with port 1.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...