07-09-2008 01:58 PM - edited 03-15-2019 11:51 AM
Any idea on how to configure the cisco ATA 188 for fax? Cus I have problem sending and receiving fax, but I can make and received calls without problems.
I attach the cisco ATA configuration.
07-15-2008 06:41 AM
Hi,
You need to confugre your dial-peer as follows..
dial-peer voice xx voip
fax rate disable
modem passthrough nse codec g711ulaw
Have a look here on how to configure the ATA for fax..
http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/sccp3_0/sccpaapd.htm
07-15-2008 01:53 PM
How do you specify the cisco ATA in the dial peer?
07-15-2008 02:56 PM
07-16-2008 02:29 AM
Your audio mode and connect mode settings are wrong...
Configuring the Cisco ATA for Fax Pass-through mode
Fax Pass-through mode requires configuring two configuration parameters:
AudioMode
ConnectMode
AudioMode
Description
The AudioMode parameter is a 32-bit value. The lower 16 bits apply to the Phone 1 port of the Cisco ATA and the upper 16 bits apply to the Phone 2 port of the Cisco ATA.
Your audio mode for fax pass throuhg for port1 of the ata should be
0xXXXX0015
and for port 2 of the ata 0x0015XXXX
Your connect mode settings should be...
ConnectMode
Description
The ConnectMode parameter is a 32-bit value. The parameter settings apply to both lines of the Cisco ATA. Configure ConnectMode after configuring AudioMode for fax pass-through mode. Cisco recommends you use the following ConnectMode setting to interoperate with a Cisco IOS gateway.
Recommended Setting
0x90000400
07-16-2008 07:22 AM
Hi in this parameter:
Your audio mode for fax pass throuhg for port1 of the ata should be
"0xXXXX0015" the "X" must be "X" or it means that I should replace the "X" for another number?
07-16-2008 07:23 AM
The X must be X, just as it is
07-16-2008 02:21 AM
Hi,
You dont specify the cisco ATA in a dial-peer.
You configure the ATA in call manager and then you create a dial-peer with its destination-pattern as the directory number of the ATA and session target as callmanager IP address.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: