12-27-2007 11:02 PM - edited 03-15-2019 07:58 AM
hi,
how to configure the ata work with my historical phone? it registers but cannot make a call because it has no buttons. you dial with turning the numbers.
12-28-2007 12:16 AM
Hi,
I don't think pulse code modulation is supported on an ata-186.
Regards,
Cédric
12-28-2007 01:37 AM
Hi,
you can use a pulse to tone dial converter for your vintage phone:
http://www.sandman.com/pdf/page91.pdf
(pedantic note: pulse code modulation is something else :)
Hope this helps, please rate post if it does!
12-28-2007 01:47 AM
That's what happens when you are replying on posts and mess with different soundconversions at the same time :)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: