I recently installed the Business Attendant Console (BACS) and was workign on redundancy solutions to take care to some issues. Say when the Operator is not logged into the AC software or for some reason the machine crashes, I want the call to routed to a huntpilot number which has all the lines for the operator's phone. But when I try to test it out since the BACS still thinks all the CTI ports are registered it still sends the call to the BACS Pilot point and the call never shows up anywhere.
Any ideas how to make this work would be really appreciated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...