Open your sniffer capture in Ethereal. Make sure to uncheck the boxes for Enable MAC name resolution and Enable transport name resolution. This greatly speeds up the load time.
Find all of your Real-Time Transport Protocol (RTP) streams and make sure they are recognized as RTP streams. If they show up as User Datagram Protocol (UDP) packets, right-click one of the packets, choose Decode As and then select RTP. Do this for all of the streams you are interested in.
Go to Analyze > Statistics > RTP Streams > Show All.
Note: The location of RTP Streams > Show all menu items may differ depending on your version of Ethereal.
You should see a window that has a list of all the RTP streams found in the capture file. Select your forward stream by clicking with the left mouse button. Select the reverse stream by holding the Shift key and left clicking on it. Above the buttons at the bottom of the window, it should now list both streams, including IP addresses (Source [SRC] and Destination [DST]) and the RTP Synchronization Source (SSRC) field.
Select the Analyze button. This pops up yet another window with detailed analysis for the RTP streams you selected previously. Select the Save Payload button. Choose which payload you want to save (forward, reverse or both), the filename and the path. This creates a .au file in the path you specified that will have both directions of the RTP stream.
If you have difficulty, make sure that before you select the Analyze button that it shows valid forward and reverse streams. If it only picks up one direction of the RTP stream, it will not allow you to save a payload with both directions selected.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...