Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco call manager V8 & HiPath 3000 via IP

I need to know whether the Cisco Call manager V8.0 has been tested/approved on a Siemens HiPath 3000 V8/V9 via IP (H323 or SIPQ). If it has is there a document outlining how it is connected and what protocol was used and what features were tested. I work for Nashua Communications in South Africa and a customer has a call manager which we need to connect to. any help in regards to certification and/or testing would help.

  • IP Telephony
1 REPLY
Hall of Fame Super Red

Cisco call manager V8 & HiPath 3000 via IP

Hi Martin,

Here is the only "interop" guide for Siemens/CUCM 8.x that I could find;

Siemens HiPath 4000 Release 5.0 using SIP trunk to Cisco Unified Communications Manager 8.5

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns784/984209.pdf

From the interop portal;

http://www.cisco.com/en/US/solutions/ns340/ns414/ns728/networking_solutions_products_genericcontent0900aecd805b561d.html

Cheers!

Rob

"Always movin' ahead and never lookin' back" - Springsteen

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
885
Views
0
Helpful
1
Replies
This widget could not be displayed.