Cisco CallManager 4.1.3 sr6a with Codian/Tandberg ISDN Gateway
I am running CCM 4.1.3 sr6a and I am trying to integrate a Codian/Tandberg ISDN gateway to CCM and I running into this weird issue, hope someone can help !!
- The Codian/Tandberg ISDN gateway itself has a built-in auto attendant and I've configured the ISDN gateway in CCM as an H.323 gateway and I can dial to the AA on the ISDN gateway by dialing a 4-digit extension from my video enabled phone but for some reason I am not getting the audio stream from the AA when dialing by 4-digit extension. But if I dial by IP address from a Tandberg video endpoint by passing CCM then it works, I get both video and audio streams. So I am suspecting there is something that is not right during call setup when CCM is involved.
Any suggestions / inputs is highly appreciated !!! Thank you all very much in advance !!!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.