I have configured a Cisco Catalyst 2960S switch for both Desktop and Voice VLANs using the Cisco Network Assistant.
The configuration is as follows:
Access VLAN: 192
Voice VLAN: 100
The configuration is working out fine but there are issues when there is a replication operation between servers A and B on the Access VLAN 192.
Servers A and B are attached to switch ports configured to be on VLAN 192 only (GigabitEthernet 1/0/23 and GigabitEthernet 1/0/24)
The replication between the two servers takes a lot of time to complete and sometimes terminates.
I have tested the replication between the same two servers on a normal switch with blank configuration and it completes successfully.
Though switch ports GigabitEthernet 1/0/20 - GigabitEthernet 1/0/24 are configured for VLAN 192 only, an IP Phone connected to these ports works the same as when connected to the remaining switch ports configured for both Access + Voice VLANs.
Please note that the IP Phones are not Cisco phones.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.