Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO CM qsiq PRI with legacy PBX, how to.

Hello to everyone,

I have to link an legacy pbx (oxo) with a cisco CM. I know there is the posibility to connect them by a pri with qsig.

Can everyone address me ?

Thank you really much

Everyone's tags (2)
3 REPLIES
Hall of Fame Super Gold

CISCO CM qsiq PRI with legacy PBX, how to.

Do you have any experience in this field? If you don't and/or have no certifications, you best choice is to engage a reputable consultant, or certified Cisco partner.

New Member

CISCO CM qsiq PRI with legacy PBX, how to.

Hello Paolo,

I am not a voice specialist, but I have several year of experiences in  networking. I never configured this kind of trunks, but I installed  severals CME and CM. I am not a total newbe. I need some documentation  where I can find how to make this link, I am a self confident I think I  can manage this installation, of course I if I cannot managed that, I  will call a voice specialist; but I would like to try.

Please Paolo, let me if you know any documentation about this issue.

Thank you.

Hall of Fame Super Gold

Re: CISCO CM qsiq PRI with legacy PBX, how to.

I would start reading CUCM documentation and SRND, then a search here and on cisco.com.

The matter has been discussed so many times, that unless you have very specific issues, doesn't deserve a new thread again.

503
Views
0
Helpful
3
Replies