Cisco CME Adding Didgits to the end of dialed numbers
Greetings, i have a CCME setup running version 7.0, inbound and outbound calls are working as expected except that call setup for outbound calls can take anywhere from 5 - 15 seconds, ive spoken with a couple of people in regards to this issue as such one person mentioned adding "#" at the end of the number which set's up the call immediately.
Is there a way i can re-configure the existing outbound translation profile to add "#" at the end of every number sent to the SIP provider.
I do realise that the Interdigit timeout value can be decreased which is currently set for 6 seconds but the telephony users report that when the timeout is set for 2 - 3 seconds it is not enough time to dial a number...oh i despair!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.