Has anyone setu faxing between CME and Exchange 2010? We have voicemail working perfectly yet I have not been able to locate any documentation/examples on setting up faxing. My own attempts have proven unsuccesful as well.
I found out that with Exchange 2010 you need a fax gateway, so I purchased some software.. however I haven't yet been able to figure out how to get the fax gatewawy software and the cisco CME router to properly communicate... so in short. Nope, haven't figured it out. I'll admit I haven't invested a whole lot of time into figuring it out.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...