Cisco CTI OS 9.0(4) error 12005 comes back after failover
We are running Cisco CTI OS 9.0(4) with UCCE 9.0(4) and CUCM 9.1. We upgraded recently and found that a number of phones required us to disable allow control of Device from CTI, reset a phone, and then enable allow control of Device from CTI on the phones due to CTI OS error 12005. We've worked through this but found after doing failover testing that we have to go through this same exercise.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...