Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco CUCM 7 e&m conference

I would like to configure a e&m port on a 2811 so that my users can dial into it.

In the past I have made it work on a one to one basis.

I would like more than than user to be able to dial in at any time.

I assume I need  to set it up as a h.323 gateway, but how do I get the "conference" functionality

1 REPLY
Bronze

Re: Cisco CUCM 7 e&m conference

Hi Martin,

Gateway needs to be configured as H323

To enable an analogue port to be able to use conferencing it needs to be controlled via SCCP as below

stcapp ccm-group 1
stcapp

dial-peer voice xx pots
description **Dial Peer for Main Conference Phone**
service stcapp
port x/x/x

ephone-dn  XX  dual-line
number XXX
label Main Conf Room
transfer-mode consult

ephone  xx
mac-address xxxx.xxxx.xxxx
max-calls-per-button 2
type anl
button  1:xx

Cheers,

Phil

208
Views
0
Helpful
1
Replies