Is it possible to use multiple gateways, in my case two, in a cisco cucm h323 environment?
I have the task of adding 6 bri lines to my central site and I only have one gateway, so i want to add another one, but i have doubts if this is possible, and if it is, how this would be done in terms of how the calls would be forwarded to the ports in the two gateways.
Can you elaborate on how you want to set this up? You could just add both routers as h323 gateways to the CUCM and then put them both into separate route groups under 1 route list. You can choose the algorithm used to choose the line within the route group.
I attached a simple design of what I want to do. I want the calls to be balanced between the two gateways, i.e., call 1 goes to gateway1, then the next call goes to gateway2, next call gateway 1, and so on.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.