Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco CUCM - Re-enable Direct Dial

  1. OK,

    CISCO is causing me a headache, any experts out there willing to contribute would help tremendously!

    I have a Direct Dial Number that when I phone it, it automatically hangs up.
    Now obviously this is because incoming calls to that DDI are being refused/denied/blocked.

    Problem is, I cannot find where to re-enable for this extension.

    Any pointers or general shoves in the right direction greatfully received!

    Thanks
     
    Cisco Unified CM Administration
     
    System version: 8.6.2.22900-9
2 REPLIES

Hi.It could be done in

Hi.

It could be done in different ways.

For example with a translation pattern with "Block This Pattern" option or the DDI configured within a partition not reachable from CSS configured as incoming CSS on Gateway/Trunk .

 

HTH

 

Regards

 

Carlo

Please rate all helpful posts "The more you help the more you learn"
Hall of Fame Super Silver

Start by looking at the debug

Start by looking at the debug of the gateway for reason of the disconnect, for example if you have PRI use "debug isdn q931" if SIP "debug ccsip messages" if POT "debug voice ccapi inout".

Chris

39
Views
0
Helpful
2
Replies
CreatePlease to create content