Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Emergency Responder

I have a switch in my Cisco CER that the CER can not see. This is the message that I get from the CER :

2010-06-06 00:16:44,464 | INFO  | CER_AGGREGATOR | This device is not supported 10.172.59.18

The switch is a cisco WS-C2960-24PC-L - ISO is :c2960-lanbase-mz.122-44.SE6/c2960-lanbase-mz.122-44.
SE6.bin

The snmp is correct. It is set up just like all the rest. Can you make any sense from that message.

Dave

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Cisco Emergency Responder

You might want to check compatibility for your version of CER i know the 3560v2 switch is only supported on CER 7.1.1B and later you probably need to upgrade CER

2 REPLIES
New Member

Re: Cisco Emergency Responder

You might want to check compatibility for your version of CER i know the 3560v2 switch is only supported on CER 7.1.1B and later you probably need to upgrade CER

New Member

Re: Cisco Emergency Responder

I am using a Cisco 2960 switch. Why can't I see that switch?

298
Views
0
Helpful
2
Replies