Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco ip phone 12 sp+

Hi

I have a cisco IP phone 12 sp+. I was trying to configure it with asterisk 1.2 which runs in Fedora Linux.I am able to get dial tone from the cisco phone,registered with asterisk at Line=>3.

Now, when i dial any number it gives the following message,

"Asked to indicate 'stop tone'

condition on channel skinny/3@ciscosp3-2"

It is collecting digit what i type follows this message and repeats this message..... No ringing tone.

Any help would be greatly appreciated.

Thanking you,

araskumar.a

1 REPLY
Bronze

Re: cisco ip phone 12 sp+

Check if asterisk supports SCCP other wise need to load a firmware for h.323 or SIP.

128
Views
0
Helpful
1
Replies