Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco IP Phone 7962 struck at Cisco boot up screen

 

 

Hello All,

 

I just received Cisco 7962G ip phones. While booting it got struck at the Cisco screen where on the left hand bottom side there is a check box. After some time it goes back to firmware upgrade screen and comes back to Cisco boot screen. I did the factory reset mentioned in https://tools.cisco.com/bugsearch/bug/CSCef22943

Its still the same. Then I did the second FR with a different code 3 4 9 1 6 7 2 8 5 0 * #
 metioned in the above link. The issue has become worse. i cannot see on the screen now. Its blank.

 

Can anyone help me with this?

 

screen shot attached

 

 

 

 

Thank you

3 REPLIES
Silver

Please use manual procedure

Please use manual procedure like:

http://draganchilly.blogspot.com/2014/02/cisco-ip-phone-recovery-procedure.html

HTH,

Dragan

HTH, Dragan
New Member

 Basically you bricked the

 

Basically you bricked the phone to a no-firmware, or almost only bootstrap firmware. Generally this is not the end.

Basically you need to place a Good DHCP with option 150, and a TFTP server with all Config and firmware files needed from the phone, in order to get back it's Operating System.

My favorite way of doing this, is setup a SPAN port on the SW, and monitor the traffic the phone is sending with Wireshark, you can then see every DNS request and TFTP request the phone is doing, and try to get the files the phone is requesting.

On the community there are some document on how to upgrade a phone firmware using TFTPd32 those might come in handy. 

 

New Member

The issue is resolved. The

The issue is resolved. The problem itself says that its related with the Firmware.

 

We have a upgrade process in pipeline at that time. We had CM 7.0 version and we migrated to 10.5 version.

 

Once we upgraded to CUCM 10.5, the phones started downloading new firware and registered.

206
Views
0
Helpful
3
Replies