Just curious what the dekphone control feature of Cisco Mobile 8.0 should accomplish? I can place a call on hold on the iphone and resume it on my 7965, but I cannot do the same action in reverse. Should I be able to do this? Also, has anyone noticed if prescence info on the CUPC client indicates their correct status if on a call on the iPhone CM8 client? My BLF indicates my line in use, but I remain Green in CUPC.
Re: Cisco Mobile 8.0 for iPhone & Deskphone control
Well, after some playing around with the new client, I discovered that when a call is active on my primary phone 7965, If I then launch the the CM8 client on iPhone I will see the option to move the call to my iPhone client. I would hope that in future versions, this can be done from within the client.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...