Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco Pix 515 not allowing SIP Trunk Traffic from CCME to Sip Provider

I have been unable to get my CCME to register to my sip provider since in installed my pix 515. can anyone advise on the proper config to pass sip traffic with nat?

1 REPLY
VIP Red

Re: Cisco Pix 515 not allowing SIP Trunk Traffic from CCME to Si

You will need to allow port 5060 UDP or TCP inbound into your firewall (on the outside interface), and statically NAT it to your CCME's private IP address

Please remember to rate useful posts, by clicking on the stars below.

347
Views
0
Helpful
1
Replies
CreatePlease to create content