Re: Cisco Unified Border Element active calls MIB or API
I have not perused the MIBS in 15.1(1)T of IOS, but I recently attended a Cisco session where this question popped up. Cisco has introduced several extensions to the CISCO-VOICE-DIAL-CONTROL-MIB and CISCO-DSP-MGMT-MIB mibs. These extensions are specific to CUBE and allow for more granular (i.e. accurate) monitoring of traffic volume. It appears that you can now get aggregate, protocol specific, dial-peer specific, and/or interface specific call rates.
Again I have not looked at this myself, but it seems that you may find what you are looking for with IOS 15.1(1)T. Here is a link that may be a good place to start:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...