This last week I was handed an ISR G2 licensed with CUBE and was told it was part of a proof of concept to centralize all the various communication circuits (connected to distributed IP-PBX's) through a cental point using SIP. While I don't disagree with this idea, I have very little familarity with this product. The additional challenge is that some of these remote IP-PBX's aren't Cisco CallManager, and some require authentication to connect to the SIP trunk. Is it possible to configure authentication on the dial-peers? Am I am perhaps out to lunch here?
Please excuse my newbie question, I appreciate all your feedback.
Thanks Tim. I am going to have to investigate more, as I am wondering if the authentication piece is actually a requirement for the other systems (as I know it won't be for the distributed UCME systems).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.