Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Unified Call Manager 6.1 and VMware 4.1

Hi

I am currently in the process of installing CUCM 6.1 on vmware so that we can test integration with AD. Im currently having problems installing installing the software. It boots up and but fails on the hard ware issues.

All our equipment is Dell and runs on Intel.

Are there any links or posts that you can assist with.

Thank you in advance.

Regards

Jay

4 REPLIES
Cisco Employee

Cisco Unified Call Manager 6.1 and VMware 4.1

Jayesh,

So the short of it is because 6.1 isnt supported on VMware.  The first version that is officially TAC supported on VMware is 8.0.2.  With that being said, for lab recreates and confirming you have successful backups, it can be advantageous to have a test setup in VMware.  You should be able to install it on VMware to test certain features.  The key for 6.1 will be to get the VMware requirements correct.  Here are the spec's that we use in our Lab testing environment for 6.1.5:

1 - vCPU

2Gb RAM

80Gb Harddrive

Virtual Machine version 7

RedHat Version 4 32-bit

Hope this helps!

-Brett Fritzsch

New Member

Cisco Unified Call Manager 6.1 and VMware 4.1

THANKS FOR THIS.

I HAVE MANAGED TO BOOT UP CUCM ON VMWARE. I GET TO THE END AND THEN GET THE MESSAGE - NO DRIVE FOUND. AN ERROR HAS OCCOURED, NO VALID DEVICES WERE FOUND ON WHICH TO CREATE NEW FILE SYSTEM PLEASE CHECK YOUR HARDWARE FOR THEW CAUSE OF THIS PROBLEM

Super Bronze

Cisco Unified Call Manager 6.1 and VMware 4.1

Hi

Did you add a SCSI or IDE virtual HDD?

I always used IDE for 6.x releases...

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Cisco Unified Call Manager 6.1 and VMware 4.1

Hi, I use this recommendation and it work in Workstation VMware 7.0,

1 - vCPU

2Gb RAM

80Gb Harddrive IDE

Virtual Machine version 7

RedHat Version 4 32-bit

THX a lot

HTH, please rate all useful posts and right answers.
1359
Views
15
Helpful
4
Replies
CreatePlease login to create content