Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Unity Connection 9.x In BE, Registered, but not working.

Hello,

I installed CUCM 9.x cluster on Cisco BE6000 servers.

After than i deploy CUC 9.x cluster. On same hardware with CUCM.

I configured integration CUC with CUCM, Voice Mail Ports Registered.

But,

When i call to pilot number - phone suspends for 10 seconds, after show "defaulting to TFTP" message, and nothing happen.

When i call from phone to phone with enabled VM profile and forwarding to VM, after 5 seconds of calling (for example 5 second NOAN), CUCM answers than called number is no available, but this phrase cuted after 1 second.

Please, can you help me with troubleshoot this issue?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Can you dial the VM pilot?Can

Can you dial the VM pilot?

Can you dial a VM port?

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
3 REPLIES
Cisco Employee

Can you dial the VM pilot?Can

Can you dial the VM pilot?

Can you dial a VM port?

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Problem with suspending was

Problem with suspending was solved, problem was with network connection, and "UCM is down" problem.

Now i can dial VMpilot, and VMport, and access CUC voice menu.

But,

When i dial a number with set up VM user, in the moment when called number must forward to a VM port, system says, that called number is not available. 

I though that it might be a "Class of control" set up incorrect. 

I checked that the CSS of the line, and forwarding CSS contains partitions with VMpilot and VMport. But it's not worked.

I can dial VMpilot, and access message box, but a can't forward incoming call to Voice Mail for leaving the message.

 

 

New Member

Jaime, thanks for showing me

Jaime, thanks for showing me direction.

Trouble was in VMpilot's CSS, i put in this CSS partition with local users, and it worked.

 

55
Views
0
Helpful
3
Replies