Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco unity express error

Hai ,

I am getting an error when i was trying to start unity express  .When i treid to enter CUE 7.0.1 it tells me to

Enter runlevel :

When I tried to Enter runLevel "2" it gives me

INIT Entering runlevel:4

INIT:no more processes left in this run level

I think software  has gone corrupted ?

How can i recover the same .

Thanks,

Harish

5 REPLIES
Hall of Fame Super Gold

cisco unity express error

Reinstall latest software.

New Member

cisco unity express error

Hai Paolo,

Thankyou for your response.

The Problem is inorder to install the software I need to atlest get into boothelper mode which I cannot .

Every time when I reload the module it asks

Enter runlevel :

When I tried to Enter runLevel "2" it gives me

INIT Entering runlevel:2

INIT:no more processes left in this run level

and after that it again reloads the module

This is the problem that I am facing .

Thanks,

Harish

Hall of Fame Super Gold

cisco unity express error

Reset CUE from router CLI and go from there.

New Member

cisco unity express error

Hai ,

Well I resetted from CLI by using service-module service-engine 0/0 reset  command but i cannot enter into CUE.

because when it enters CUE it tells

Enter runlevel :

When I tried to Enter runLevel "2" it gives me

INIT Entering runlevel:2

INIT:no more processes left in this run level

and after that it again reloads the module

This is the problem that I am facing .

Is there any way I can put the Linux OS for CUE to flash.I cannot use Boothelper because I cannot enter into Boothelper mode.

Thanks,

Harish

Hall of Fame Super Gold

cisco unity express error

When CUE is reset will show "Enter *** to interrupt". All that is explained in documentation.

228
Views
0
Helpful
5
Replies
CreatePlease login to create content