Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Unity Express Failed

Hi

I upgraded my CUE to version 3.2 and after it stated all successful I rebooted the service module and now it constantly says that it has failed. I tried to reload and keep getting this status.

SC-RTR#service-module service-Engine 0/1 statu

Service Module is Cisco Service-Engine0/1

Service Module supports session via TTY line 258

Service Module is trying to recover from reset/shutdown

Service Module heartbeat-reset is enabled

Service Module status is not available

Is there any other way to try and recover the module

Paul

3 REPLIES

Re: Cisco Unity Express Failed

Reloading the router should have fixed the problem... but if you have tried that perhaps you coulds try unplugin the router leave it for a minute and then plug it back...

New Member

Re: Cisco Unity Express Failed

Thanks for the info! My CUE was stuck in a loop after I tried to do a clean install. After unplugging it, leaving it for a minutes aside and re-insert it and now I can reinstall the soft :-)

Greets,

David

Bronze

Re: Cisco Unity Express Failed

When you reload the router by the reload command, it doesn't power down/reload the CUE module. To reload the CUE module, put in:

service-module integrated-Service-Engine 0/0 reset

Where the 0/0 is the slot your CUE module is in.

Please rate if this helps.

280
Views
0
Helpful
3
Replies
CreatePlease to create content