08-06-2015 01:32 AM - edited 03-17-2019 03:54 AM
Hi,
My installation is:
Germany Telecom (E1) --> (E1) Cisco Voice Gateway H323 (E1- Emulate Network)) --> PBX Siemens (version 3)
When i call of external --> Siemens Phone it's ok.
But when i call Siemens Phone --> external is no good. The siemens send the number digit by digit.
I would like make this (digit by digit) with my voice gateway and i don't find the command.
Thank your help.
08-13-2015 05:05 AM
Hi all,
I have news, the Siemens PBX give me only 3 digits in my serial 0/1/0:15 and not more.
but i call with 10 digits. I not think that the problem is enbloc configuration.
my serial configuration is :
interface Serial0/0/1:15
description SIEMENS
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn protocol-emulate network
isdn overlap-receiving
isdn incoming-voice voice
isdn send-alerting
isdn negotiate-bchan resend-setup
isdn sending-complete
no cdp enable
Have you idea.
08-13-2015 06:48 AM
What are your dial-peers looking like when the Siemens passes the call to the voice gateway outbound?
08-19-2015 05:56 AM
Hi,
I find my problem.
I add on my serial this :
isdn timer T203 30000
isdn timer T310 60000
The Siemens PBX work digit by digit and not enbloc.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: