Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco voicegateway

I have MD110 as pbx. the MD has E1 link from telco to provide outside calls.

I defined in my VG "9" for going out .

when a user dial 9 two problem occures:

1) the user hears some kind of noises!!

2)the user can not here dial tone

please help

14 REPLIES
Hall of Fame Super Gold

Re: Cisco voicegateway

What exactly is the VG and how is connected to rest of the other things ?

New Member

Re: Cisco voicegateway

The VG is cisco 2821 and is connected via E1 to pbx.

New Member

Re: Cisco voicegateway

Could you upload the configuration for better understanding

Hall of Fame Super Gold

Re: Cisco voicegateway

Hi,

where are you calling with "9" ?

New Member

Re: Cisco voicegateway

hi

here is my config:

dial-peer voice 10 pots

port 0/2/0:15

forward digit all

destination-pattern 9

----------------------

when I dial i can not here PSTN dial-tone from pbx.also the important thing is that when I dial 9 no time slot activation happend

i hear just noise some kind "shshshshsh"

in this point i can dial my number after finishing my dial the connection established.

but i want to hear PSTN dial tone after dialing 9

thank you

Hall of Fame Super Gold

Re: Cisco voicegateway

Hi, you are not calling any number because the 9 is absorbed being it pots DP. Add "no strip-digit" and PBX should connect you to PSTN. You can also do a DP like 9.....T this way you can call directly, no need to wait for dialtone.

Please rate post if it helps!

New Member

Re: Cisco voicegateway

Hi again

its mandatory to hear pstn dialtone.

please guide me to hear PSTN dialtone.

waiting for you reply

Hall of Fame Super Gold

Re: Cisco voicegateway

As mentioned before, configure as indicated and you should have dialtone from PSTN.

New Member

Re: Cisco voicegateway

hi

I will do your command and will let you know

New Member

Re: Cisco voicegateway

Dear freind

i provide my your command but still can not hear PSTN dial tone

can you provide me something else?

regards

Hall of Fame Super Gold

Re: Cisco voicegateway

Are you using CM or CME ? Sometime you can configure "secondary dialtone" to emulate PSTN dialtone.

New Member

Re: Cisco voicegateway

there is no any CM or CME on my network

there is just ericcson MD110 and cisco gateway (CISCO 2811)

we are trying to make call from PBX extentions.

but still we can not here PSTN dial tone!

its very importatnt..

if you need further information let me know.

thank you for following up

Hall of Fame Super Gold

Re: Cisco voicegateway

The 2821 is connected to both PBX and PSTN ? And to for which purpose ?

Please specify with a diagram all that is connected as requested before.

New Member

Re: Cisco voicegateway

here is diagram

PSTN---PBX1----Router----IP-----Router----PBX2--users

147
Views
0
Helpful
14
Replies