Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Voip Router to Linksys Voip Router Call

Hi,

I have Cisco 1760 voip router with two fxs ports. And have Linksys WAG54GP2-E2 voip router. I make peer-to-peer call. Linksys router can call to cisco but cisco can not call linksys. Does anybody know how i resolve this problem. Thank for help.

Ufuk Guler

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Cisco Voip Router to Linksys Voip Router Call

You are right, I had totally oversight that you was missing that command under DP!

Good that you've found about it eventually.

5 REPLIES
Hall of Fame Super Gold

Re: Cisco Voip Router to Linksys Voip Router Call

How DP on the 1760 is configured, and what do you see from "term mon" and "debug ccsip message" ?

New Member

Re: Cisco Voip Router to Linksys Voip Router Call

Here is DP,

dial-peer voice 200 voip

description *****CISCO TO LINKSYS*****

destination-pattern 200

voice-class codec 1

session target ipv4:81.x.x.x

dtmf-relay cisco-rtp

no vad

When i test with csim start 200 command i take this messages

csim: called number = 200, loop count = 1 ping count = 0

csim err csimDisconnected recvd DISC cid(507)

csim info: cid(507), state(0), cause(38)

csim: loop = 1, failed = 1

csim: call attempted = 1, setup failed = 1, tone failed = 0

Hall of Fame Super Gold

Re: Cisco Voip Router to Linksys Voip Router Call

cause 38 is network out of order. Please collect the above mentioned debug to find why.

New Member

Re: Cisco Voip Router to Linksys Voip Router Call

Hi,

I have checked some debug messages which are debug cch323 all. I saw that peer to peer calls like H.323 calls. And linksys accepts only SIP calls. Because of that Cisco's calls unrecognized with Linksys. Then I wrote "session protocol sipv2" command in the dial-peer. And finally, cisco calls started successfull1y to linksys.

I would like to thank you for your help.

Have a nice days...

Hall of Fame Super Gold

Re: Cisco Voip Router to Linksys Voip Router Call

You are right, I had totally oversight that you was missing that command under DP!

Good that you've found about it eventually.

456
Views
0
Helpful
5
Replies