Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco VWIC-1MFT-T1 Voice-Port Problem

Hi guys,

I'm trying to configure a T1 controller (VWIC-1MFT-T1) for voice which is installed on a 2651XM (12.4(15)T9).

After I've set it up, it came up and the serial0/0:0 was created and was up.

The problem is I can't find any voice-port in the config. It seems the voice-port 0/0:0 isn't created.

Has anyone had this issue before?

#sh run | i voice-port

#

Thanks.

Regards

4 REPLIES
New Member

Cisco VWIC-1MFT-T1 Voice-Port Problem

Stephan,

Would you please provide output for the following commands? Thanks.

sh run

sh isdn service

sh isdn status

VIP Purple

Cisco VWIC-1MFT-T1 Voice-Port Problem

Hi,

Can u also share the show diag/ show inventory  as well ?

Have u inserted VWIC in NM-V card?

regds,

aman

New Member

Hi,that's the problem I think

Hi,

that's the problem I think. It must be used with a nm-v card.

I found this post https://supportforums.cisco.com/discussion/11758746/using-vwic-1mft-t1-voice-pri-2610xm

same problem.

Thanks

Re: Cisco VWIC-1MFT-T1 Voice-Port Problem

Hi Stephan,

Do you see the controller T1 when you do the show running. If not then you have to run commands card type t1 slot#.

Slot # can be easily got from sh inventory result.

after that it would be activated and then you woule be able to see and configure T1, also would be able to configure the serial interface.

Kind Regards,

Raaj.

104
Views
0
Helpful
4
Replies
CreatePlease to create content