The first thing to understand is that routing on CUCM is done by best match - so if you dial 1234, and there are two route patterns available (e.g. 12xx and 123x) then it will match the 123x route pattern.
The partition order in a CSS is there as a tie breaker. So:
- It is not possible to add two identical patterns/DNs to the same partition. The two examples above (12xx and 123x) are different, so could go in a single partition. However - you could not add 123x twice to the same partition.
- If the same pattern/DN exists in two partitions, then the order within the CSS breaks the tie. the highest order partition is where the call is routed.
Please rate helpful posts..
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
does it means that when i dial 1234 and if i want match the 12xx route patten(not 123x), i should config two different partitions and make the 12xx partition in the first order of the css list, is that right?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...